Kicker ZX300.4 User Manual download pdf (Page 4)

ZX AMPLIFIERS

AUTO

TURN ON

+12V DC AUDIO

OFFSET

XOVER

OFF LO

REMOTE BASS

INPUT

SPKR + SPKR -

OUTPUT

INPUT

SENSITIVITY

OFF

BASS

BOOST

GAIN

LLRR

+–

MONO OPERATION

minimum impedance of 2 ohms

signal in signal out

woofer

ZX300.1

OPERATION

AUTO

TURN ON

+12V DC AUDIO

OFFSET

XOVER

OFF LO

REMOTE BASS

INPUT

SPKR + SPKR -

OUTPUT

INPUT

SENSITIVITY

OFF

BASS

BOOST

GAIN

LLRR

Automatic Turn-On Selection: The ZX series offers three different automatic turn-on modes that can be

selected on the end panel; +12V, DC Offset, and Audio. Using either the DC Offset or Audio mode causes the

REM terminal to have +12V out for turning on additional ampliﬁ ers.

• Remote Turn-On: Set the switch to +12V to use the remote turn-on lead from your source unit. Run 18

gauge wire from the Remote Turn-On Lead on your source unit to the terminal labeled REM between the

ampliﬁ er’s positive and negative power terminals. This is the preferred automatic turn-on method.

• DC Offset Turn-On: If Remote Turn-On is not an option, the next best setting is DC Offset. The DC Offset

mode detects a 6V DC offset from the HI-Level speaker outputs when the source unit has been turned on.

• Signal Sense Turn-On: The Audio setting is the ﬁ nal alternative for Automatic turn-on. This is a Signal Sense

turn-on method that detects the incoming audio signal from your source unit and automatically turns on the

amp. This turn-on method will not work properly if the input gain control is not set appropriately.

2010 ZX 300.1 400.1 500.1 750.1 RevC.indd 42010 ZX 300.1 400.1 500.1 750.1 RevC.indd 4 10/15/2009 10:55:55 AM10/15/2009 10:55:55 AM

1 2 3 4 5 6 7 8 9 ... 27 28

Comments to this Manuals

No comments

Kicker ZX300.4 User Manual Page 4

Comments to this Manuals

Related products and manuals for Car amplifier Kicker ZX300.4