DE & SE SERIES
SUBWOOFER ENCLOSURE SYSTEMS
INSTALLATION INSTRUCTIONS
After determining the mounting position, turn the enclosure upside-down and attach
the four mounting brackets to the bottom of the enclosure using the enclosed small
screws. Each bracket must be positioned so the rounded end protrudes approximately
3/4 inch from under the cabinet to allow a screw to easily pass through it for
attachment to the vehicle.
Plug the speaker wires securely into the left and right speaker terminals. Make certain
the polarity is the same on both sides. Failure to do this will result in the two channels
being out of phase and will drastically reduce bass performance.
Position the enclosure in its mounting position and securely attach it to the vehicle with
the enclosed large screws. If the brackets and screws are not applicable to your installation,
some other means must be used to secure the enclosure to your vehicle.
IMPORTANT WARNING
To avoid potential injury from forward movement of the enclosure during abrupt stops or
accidents, this enclosure must be properly installed and securely fastened to your vehicle.
Comments to this Manuals