Kicker SKM10 Owner's Manual download pdf (Page 3)

MOUNTING

After determining the best mounting location, and subwoofer ﬁ ring position, carefully check the areas

where the mounting brackets will be placed. Make sure the mounting screws will not puncture the fuel

cell, wiring, or interfere with any mechanical parts on the underside of the mounting surface.

Decide if you want the mounting ﬂ ange positioned under the enclosure or exposed. Attach the two

mounting brackets to the sides of the SKM enclosure using the supplied stainless steel machine screws.

Pre-drill the mounting screw

holes using a 7/64” (2.5mm) bit,

and attach the SKM enclosure

to the boat, by fastening the

supplied stainless steel course-

threaded screws into the mounting

bracket ﬂ ange and into the

boat’s structure. If the supplied

hardware is not applicable to your

installation, some other means of

securely attaching the enclosure

to the vessel must be used.

SAFETY WARNING

To avoid potential injury, or possible death, from forward movement of the enclosure during abrupt stops

or accidents, the enclosure must be properly installed and securely fastened to your vehicle. You are

solely responsible for securely fastening the enclosure in your vehicle.

WIRING

Remove the cover for the speaker terminal cup, plug your

subwoofer speaker wire into the terminals, using the red

connector as positive and the black connector as negative.

Connect the other end of the wire to your subwoofer

ampliﬁ er in accordance with its owner’s manual. Replace

the cover for the speaker terminal cup, by snapping it into

place..

MODEL:

SKM10

Nominal Impedance [Zn] | ohms [per enclosure] 4

Power Handling* | Watts Peak [RMS] 300 [150]

Enclosure Depth | in [cm] 8 5/16 [21.1]

Enclosure Height | in [cm] 16 1/16 [40.8]

Enclosure Width | in [cm] 23 15/16 [60.8]

Note: The use of a subsonic ﬁ lter will signiﬁ cantly increase power handling. The power handling speciﬁ cation in this chart

is calculated using a 25Hz, 24dB/octave subsonic ﬁ lter. Kicker Marine speakers use the highest level of magnetic shielding

available to minimize compass and gauge deviation in your dash. Kicker Marine speakers meet or exceed industry standards

for environmental humidity and corrosion, and for material degradation due to UV exposure.

SPKR +

SPKR -

Mounting Flange exposed

Mounting Flange tucked

under the enclosure

Speaker

Terminal Cup

Cover

*Power Handling Watts RMS without subsonic ﬁ lter: SKM10-125

1 2 3 4 5 6 7 8 ... 11 12

Comments to this Manuals

No comments

Kicker SKM10 Owner's Manual Page 3

Comments to this Manuals

Related products and manuals for Car speakers Kicker SKM10